Modify Fc/Fcoe Host - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.2 Host Group Management
2
Click the [OK] button.
 Deletion of the SAS host starts.
3
Click the [Done] button to return to the [SAS Host] screen.
4.2.15

Modify FC/FCoE Host

This function changes the FC/FCoE host information.
• When no FC/FCoE hosts are registered, the [Modify FC/FCoE Host] function cannot be used.
• When changing the WWN of an FC/FCoE host that is currently being used, make sure to stop access to that
FC/FCoE host.
• This function can change the following FC/FCoE host information; "Name" and "WWN". When the FC host
is not registered in a host group, the "Host Response" setting can also be changed.
• When the FC host is registered in a host group, use the [Modify Host Group] function to change the host
response. Refer to
• Both "FC host" and "FCoE host" are abbreviated as "FC host" in this section.
For details on the parameters for this function, refer to
The procedure to change the FC host information is as follows:
Procedure
1
Select the FC host to change the host information for, and click [Modify FC/FCoE Host] in
[Action].
"4.2.6 Modify Host Group (FC/FCoE)" (page 386)
423
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for details.
"A.4.2.10 Modify FC/FCoE Host" (page
End of procedure
834).
P2X0-1270-13ENZ0