Fujitsu ETERNUS DX60 S3 User Manual page 875

Appendix A Parameter List
A.4 Connectivity Management
●
Other Settings
• Command Monitor Time
Description
Input condition/
Display contents
• Load Balance Response Status
Description
Input condition/
Display contents
This item is only available when "Enable" is selected for "Load Balance" in the subsystem parameter.
• iSCSI Discovery Reply Mode
Description
Input condition/
Display contents
• iSCSI Reservation Range
Description
Input condition/
Display contents
Select one of the following options for command timeouts.
•
Default (25sec.)
Specify 25 seconds.
•
Customize
Input a value between 10 and 255 seconds.
Select the response status for the load balancing function.
•
CHECK CONDITION / UNIT ATTENTION (Default)
•
BUSY
•
TASK SET FULL
Select the response mode for iSCSI Discovery requests.
•
All - Reply All Ports (Default)
Replies to the server with the information for all the iSCSI ports (iSCSI names and IP
addresses).
•
Port - Reply Target Port Only
Replies to the server with only the information for the specified iSCSI ports (iSCSI
names and IP addresses).
Select the reservation management unit of the iSCSI connection.
•
Storage System (Default)
The reservation status of volumes is managed for each storage system.
•
CA Port
The reservation status of volumes is managed for each CA port.
875
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0