Chapter 7 Advanced Copy Management
7.7 Modify Copy Parameters
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to modify copy parameters is as follows:
Procedure
1
Click [Modify Copy Parameters] in [Action].
2
Specify the threshold for each policy level.
The main setting items are as follows.
●
Policy of Snap Data Pool
•
Policy Level 1 (Informational) Threshold
•
Policy Level 2 (Warning) Threshold
•
Policy Level 3 (Error) Threshold
●
SDPE Setting
•
SDPE
If the magnitude relation is not "Threshold for a policy level 1" < "Threshold for policy level 2" <
"Threshold for policy level 3", an error screen appears. If this occurs, check the parameter settings.
3
Click the [Modify] button.
A confirmation screen appears.
4
Click the [OK] button.
The specified copy parameters are registered.
5
Click the [Done] button to return to the [Snap Data Pool] screen.
609
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.7.4 Modify Copy Parameters" (page
"Appendix B Modify Copy Parameters" (page
941).
1010).
End of procedure
P2X0-1270-13ENZ0