Fujitsu ETERNUS DX60 S3 User Manual page 730

Appendix A Parameter List
A.1 System Management
• Drive Error of HDD Shield
Description
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
• Succeeded HDD Shield
Description
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
• Temperature Error
Description
• End of battery life
Description
• Rebuild/Copyback w/ redundant
Description
Select whether to notify when a failure occurs in a protected (shielded) drive for each
condition that is described below. When notifying, select the notification method.
•
Any Time
Notifies always when a failure occurs in a protected (shielded) drive.
•
when HS<0
Notifies only when a failure occurs in a protected (shielded) drive while available hot
spare disk is " 0" (*1).
*1: When rebuilding cannot be performed because there are no hot spares that can be
used as a substitute for the failed drive.
Select whether to notify when a failed drive is diagnosed as being available by the
protect (shield) function and is activated in the ETERNUS DX. When notifying, select the
notification method.
Select whether to notify when a temperature error status is detected by the sensor. When
notifying, select the notification method.
Select whether to notify when a battery expires. When notifying, select the notification
method.
"End of battery life" notification is available only for the ETERNUS DX500 S3/DX600 S3
and the ETERNUS DX8700 S3/DX8900 S3.
Select whether to notify when rebuilding or copy backing (with redundancy) (*1) is
performed. When notifying, select the notification method.
*1: "Rebuilding to hot spare disk is complete", "Copyback starts" and "Copyback
complete" are equivalent to "Redundancy".
730
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0