Fujitsu ETERNUS DX60 S3 User Manual page 848

Appendix A Parameter List
A.4 Connectivity Management
A.4.3.7 Modify iSCSI Port Parameters
For details about this function, refer to
For the factory default settings for this function, refer to the following sections:
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "CA")" (page 995)
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "RA")" (page 996)
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "CA/RA")" (page 997)
• "Appendix B Modify iSCSI Port Parameters (when the port type is "iSCSI RA (for older storage system
connection)")" (page 998)
• "Appendix B Modify iSCSI Port Parameters ([Send Ping] screen)" (page 998)
●
Select Port
• Port
Description
Input condition/
Display contents
●
General Information
• iSCSI Settings
- iSCSI Name
Description
Input condition/
Display contents
•
The same iSCSI name cannot be set to multiple iSCSI ports except the device iSCSI name.
•
This item is not displayed when the port type is "iSCSI RA (for older storage system connection)".
- Alias Name
Description
Input condition/
Display contents
"4.3.8 Modify iSCSI Port Parameters" (page
Select the target port.
The selectable port locations (x: CE number, y: CM number, z: CA number, w: Port
number) are displayed as options.
•
For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
•
For the other models
CM#y CA#z Port#w
Input the iSCSI name of the target port.
Click the [Default] button to set the default iSCSI name.
•
4 - 223 alphanumeric characters and symbols ('-', '.', ':')
•
The name starts with "iqn." or "eui."
Input the alias name of the target port (can be omitted).
While the iSCSI name is a formal nomenclature that specifies the target iSCSI port, an
alias name is used as nickname.
An alias name that is the same as another port cannot be specified.
Up to 31 alphanumeric characters
848
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
446).
P2X0-1270-13ENZ0