Appendix A Parameter List
A.1 System Management
A.1.7.3
Setup SNMP Agent Basic Interface
For details about this function, refer to
For the factory default settings for this function, refer to
980).
●
Basic Interface
•
SNMP Function
Description
Input condition/
Display contents
•
LAN Port used for SNMP
Description
Input condition/
Display contents
•
Authentication Failure
Description
Input condition/
Display contents
•
Engine ID
Description
Input condition/
Display contents
"1.8.3 Setup SNMP Agent Basic Interface" (page
Select whether to "Enable" or "Disable" the SNMP function.
•
Enable
•
Disable
When enabling the SNMP function, select the port used for SNMP.
When sending a SNMPv1 trap, the agent-address of the trap sender is the Master CM IP
address of the selected port.
•
MNT
•
RMT
When enabling the SNMP function, select "Send SNMP Trap" or "Do not send SNMP Trap"
when authentication fails.
•
Send SNMP Trap
•
Do not send SNMP Trap
When enabling the SNMP function, input the engine ID of the SNMP.
The engine ID is a unique identifier used to distinguish the connection target storage
system between the SNMP Agent Manager and the SNMP Agent.
It is not necessary to change the default setting for normal use. The default engine ID of
the ETERNUS DX is as follows:
•
Octet 1 - 4
Bitwise OR between the company code (fujitsu=211) and 0x80000000
•
Octet 5
0x80 (fixed)
•
Octet 6 - 13
WWN of the ETERNUS DX (8 bytes)
•
Default
•
Customize
Input condition when selecting "Customize"
-
Alphanumeric characters (0 - 9, A - F, a - f)
-
Inputting only "0" or "F" for the "Engine ID" field is not allowed
-
10 - 64 characters (even number)
710
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Appendix B Setup SNMP Agent Basic Interface" (page
111).
P2X0-1270-13ENZ0