Nas Recovery Management; Force Enable Module - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 2 Component Management

2.8 NAS Recovery Management

2.8 NAS Recovery Management
This section describes NAS recovery management.
The ETERNUS DX60 S3, the ETERNUS DX8700 S3/DX8900 S3, and the ETERNUS DX200F do not support the
NAS recovery management.
NAS recovery management provides the following functions:

• Force Enable Module

• Recover NAS Engine
• Recover NAS System Volume
2.8.1 Force Enable Module
This function forces the component to be enabled without replacing it (called "force enable" hereinafter).
• Force enable can be performed only on one component at a time.
• This function cannot be used when a component whose state is other than "
This function is available for "NAS-CA" and "NAS Engine".
The procedure to perform force enable is as follows:
Procedure
1
Select the component to perform the force enable on, and click [Force Enable] in [Action].
 A confirmation screen appears.
2
Click the [OK] button.
 The force enable starts.
245
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
Error" is selected.
P2X0-1270-13ENZ0