Chapter 1 System Management
1.8 Network Management
5
Click the [Done] button to return to the [Network] screen.
1.8.3
Setup SNMP Agent Basic Interface
This function sets up the SNMP Agent basic interface in the ETERNUS DX.
SNMP is a standard protocol used for network management.
•
When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in "Allowable IP Address" using the procedure in
Setup Network Environment" (page
•
Before enabling the SNMP function, use the procedure in
"SNMP" for the setting target LAN port.
•
By using
Refer to "Initial Setup" in "FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)". When the [Initial
Setup] function is not used, configure the SNMP Agent environment in the following order:
-
When using SNMPv1 or SNMPv2c for SNMP communication
(1)
Setup SNMP Agent Basic Interface
(2)
Setup SNMP Manager
(3)
Setup SNMP Agent MIB Access View
(4)
Setup SNMP Agent Community
(5)
Setup SNMP Agent Trap
-
When using SNMPv3 for SNMP communication
(1)
Setup SNMP Agent Basic Interface
(2)
Setup SNMP Manager
(3)
Setup SNMP Agent MIB Access View
(4)
Setup SNMP Agent User
(5)
Setup SNMP Agent Trap
•
The parameter settings specified using this function remain even when the "SNMP Function" setting is
changed from "Enable" to "Disable".
For details on the parameters for this function, refer to
710).
For the factory default settings for this function, refer to
980).
97).
"1.1 Initial Setup" (page
27), the SNMP Agent environment can be configured with the wizard.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.8.2 Setup Firewall" (page 109)
"A.1.7.3 Setup SNMP Agent Basic Interface" (page
"Appendix B Setup SNMP Agent Basic Interface" (page
111
End of procedure
"1.8.1
to allow the
P2X0-1270-13ENZ0