Table 28 Snmp Specifications - Fujitsu ETERNUS DX100 S4 Design Manual

2. Basic Functions
Operation Management/Device Monitoring
●
E-Mail
When an event occurs, an e-mail is sent to the specified e-mail address.
The ETERNUS DX supports "SMTP AUTH" and "SMTP over SSL" as user authentication. A method
can be selected from CRAM-MD5, PLAIN, LOGIN, or AUTO which automatically selects one of
these methods.
●
Simple Network Management Protocol (SNMP)
Using the SNMP agent function, management information is sent to the SNMP manager (network
management/monitoring server).
The ETERNUS DX supports the following SNMP specifications.

Table 28 SNMP Specifications

Item
SNMP version
MIB
Trap
●
Syslog
By registering the syslog destination server in the ETERNUS DX, various events that are detected
by the ETERNUS DX are sent to the syslog server as event logs.
The ETERNUS DX supports the syslog protocol which conforms to RFC3164 and RFC5424.
●
Remote Support
The errors that occur in the ETERNUS DX are notified to the remote support center. The ETERNUS
DX sends additional information (logs and system configuration information) for checking the error.
This shortens the time to collect information.
Remote support has the following maintenance functions.
• Failure notice
This function reports various failures, that occur in the ETERNUS DX, to the remote support cen-
ter. The maintenance engineer is notified of a failure immediately.
Fujitsu Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Design Guide (Basic)
Specification
SNMP v1, v2c, v3
MIB II
FibreAlliance MIB 2.2
Unique MIB
Unique Trap
83
Copyright 2023 Fujitsu Limited
Remarks
—
Only the information managed by the ETERNUS
DX can be sent with the GET command.
The SET command send operation is not suppor-
ted.
This is a MIB which is defined for the purpose of FC
base SAN management.
Only the information managed by the ETERNUS
DX can be sent with the GET command.
The SET command send operation is not suppor-
ted.
This is a MIB in regard to hardware configuration of
the ETERNUS DX.
A trap number is defined for each category (such
as a component disconnection and a sensor error)
and a message with a brief description of an event
as additional information is provided.
P3AM-7642-32ENZ0