Chapter 1 System Management
1.8 Network Management
4
Click the [OK] button.
Returns to the original screen.
5
Repeat
6
After adding or editing the MIB View, click the [Set] button.
A confirmation screen appears.
7
Click the [OK] button.
Setting of the SNMP Agent MIB View starts.
8
Click the [Done] button to return to the [Network] screen.
1.8.6
Setup SNMP Agent User
This function sets up the user which accesses the SNMP Agent.
The security level and the MIB access range are configured for each user.
Up to ten users can be specified for each ETERNUS DX.
•
If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
•
The user name that is used in the settings in
changed or deleted. However, note that some of the user information (MIB View Setting, Authentication,
and Encryption) can be changed.
•
This function must be used when using SNMPv3 in SNMP communication between the SNMP Agent and
the SNMP Manager. This setting is not necessary when SNMPv1 or SNMPv2c is used for SNMP
communication.
Step 2
through
Step 4
to configure multiple MIB Views.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.8.8 Setup SNMP Agent Trap" (page 123)
117
End of procedure
cannot be
P2X0-1270-13ENZ0