Fujitsu ETERNUS DX60 S3 User Manual page 447

Chapter 4 Connectivity Management
4.3 CA Port Group Management
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to the following sections.
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "CA")" (page 995)
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "RA")" (page 996)
• "Appendix B Modify iSCSI Port Parameters (when the port mode is "CA/RA")" (page 997)
• "Appendix B Modify iSCSI Port Parameters (when the port type is "iSCSI RA (for older storage system
connection)")" (page 998)
• "Appendix B Modify iSCSI Port Parameters ([Send Ping] screen)" (page 998)
The procedure to set iSCSI port parameters is as follows:
Procedure
1
Select which iSCSI port to set the parameters for (multiple selections can be made) and click
[Configure iSCSI Port] in [Action].
• Multiple "1G iSCSI" or "10G iSCSI" type iSCSI ports with the same port mode can be selected.
Multiple "iSCSI RA (for older storage system connection)" ports can also be selected.
• Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.
2
Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port type and the port mode
mode is "CA"" (page
(page 450), or
■ When the port mode is "CA"
When the type is "1G iSCSI" or "10G iSCSI" and the port mode is "CA", specify the following items:
447), "When the port mode is "RA"" (page
"When the port type is "iSCSI RA (for older storage system connection)"" (page
447
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.4.3.7 Modify iSCSI Port Parameters" (page
449), "When the port mode is "CA/RA""
848).
("When the port
451)).
P2X0-1270-13ENZ0