Start Snapopc - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 7 Advanced Copy Management

7.1 Start SnapOPC+

7.1 Start SnapOPC+
This function is used to select the copy source volume and copy destination volume, and start a new SnapOPC+
copy session.
The maximum number of sessions and the maximum number of generations for each model
ETERNUS DX60 S3
ETERNUS DX100 S3
ETERNUS DX200 S3
ETERNUS DX500 S3/DX600 S3
ETERNUS DX8700 S3/DX8900 S3
ETERNUS DX200F
*1: The maximum number of generations for a SnapOPC+ from a single copy source volume.
• Registering the license for the Advanced Copy function is required to start a SnapOPC+ session.
• Only SnapOPC+ copy sessions that are performed in units of volumes can be created using ETERNUS Web
GUI.
To create EC, OPC, QuickOPC, SnapOPC, SnapOPC+ sessions using range selection, and REC sessions, use
copy management software.
• When using SnapOPC+, make sure to create SDVs and SDPVs. For generation management, create SDVs
for each generation. Refer to
• An ODX Buffer volume cannot be specified as a copy source.
The procedure to start the SnapOPC+ session is as follows:
Procedure
1
Click [Start SnapOPC+] in [Action].
Model The maximum number of sessions
1024
2048
8192
32768
2048
"3.1 Create Volume" (page 253)
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
(per storage system)
for details.
592
The maximum number of generations
(*1)
512
P2X0-1270-13ENZ0