Appendix A Parameter List
A.4 Connectivity Management
•
Frame Size
Description
Input condition/
Display contents
•
Reset Scope
Description
Input condition/
Display contents
This item is displayed when the port mode is "CA" or "CA/RA".
•
Release Reservation if Chip is Reset
Description
Input condition/
Display contents
This item is displayed when the port mode is "CA" or "CA/RA".
•
REC Line No.
Description
Select the frame size (bytes) of the target port.
"Frame Size" specifies the length of the communication information.
•
512
•
1024
•
2048
Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers.
•
I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
•
T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to the
port.
Select whether to "Enable" or "Disable" the function to release the reserved status of the
volume when the target port (chip) is reset.
•
Enable
•
Disable
Select the REC line number of the target port.
The REC line number is used to switch the communication path when a line fails. The
REC line number is used to recognize failed lines. Set different REC line numbers for each
physical communication path. When lines are in normal status, an REC can be performed
regardless of the REC line number (specifying the same REC line numbers is allowed) in
the same way as conventional REC operations. Note that no priority applies to REC line
numbers.
This item is displayed only when the Advanced Copy license has been registered.
844
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
P2X0-1270-13ENZ0