Set Fcoe Port Qos - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
4.7.13

Set FCoE Port QoS

This function specifies the bandwidth limit (maximum performance limit) for the FCoE port.
• The ETERNUS DX60 S3 and the ETERNUS DX200F do not support this function.
• This function can be used, irrespective of whether the QoS mode has been enabled or disabled. If the QoS
mode has been disabled, the port starts the operation within the configured bandwidth limit after the
QoS mode is enabled.
• Configure the host bandwidth limit on each host. Refer to the following sections for details:
- "4.7.7 Set FC/FCoE Host QoS" (page 489)
- "4.7.8 Set iSCSI Host QoS" (page 490)
- "4.7.9 Set SAS Host QoS" (page 492)
• The LUN bandwidth limit can be configured in the LU QoS group. Refer to
482) for details.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the FCoE port QoS is as follows:
Procedure
1
Select the FCoE port to set the bandwidth limit (multiple selections can be made), and click
[Set FCoE Port QoS] in [Action].
2
Select the FCoE port bandwidth limit.
498
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"4.7.3 Set Host-LU QoS" (page
"A.4.6.8 Set FCoE Port QoS" (page
"Appendix B Set FCoE Port QoS" (page
881).
1001).
P2X0-1270-13ENZ0