Fujitsu ETERNUS DX60 S3 User Manual page 194

Chapter 1 System Management
1.13 Remote Support Management (REMCS)
• REMCS cannot be used when the AIS Connect function is being used. Disable the AIS Connect function,
and then set the remote support (REMCS) parameters. Refer to
(page 206)
• Use the IPv4 addresses for the IP addresses of the proxy server, the SMTP server, the POP server, and the
HTTP server. IPv6 addresses cannot be used.
• When changing the registered information, use the procedure in
(page 196)
• The information files (customer information file and communication environment information file)
created by using REMCS Environment Setup Assist Tool (REMCS ESAT) can be imported to the storage
system, to simplify the input operation required to be set for each storage system.
- Only the common device information can be imported from the information file. The individual device
information is required to be specified after importing the information file.
- Just importing the information file will not automatically update the information in the ETERNUS DX.
After specifying all the necessary information, click the [Set] button.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to specify the Remote Support settings is as follows:
Procedure
1
Click [Setup Remote Support] in [Action].
2
Specify the parameters.
for details.
and the "1.13.4 Update Communication Environment Information" (page
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.14.1 Setup AIS Connect Environment"
"1.13.3 Update Customer Information"
"A.1.12.1 Setup Remote Support" (page
"Appendix B Setup Remote Support" (page
194
198).
761).
984).
P2X0-1270-13ENZ0