Fujitsu ETERNUS DX60 S3 User Manual page 424

Chapter 4 Connectivity Management
4.2 Host Group Management
2
Input new host information.
The main setting items are as follows.
●
FC/FCoE Host Setting
• Name
• WWN
• Host Response
• The range of LUNs that can be recognized from the host are determined by the "LUN Addressing"
settings and the "LUN Expand Mode (Peripheral Device Addressing)" settings for the host
response. Before changing a host response, check the LUN setting state. If LUNs that are LUN#256
onward are used, the recognizable LUN setting cannot be changed to a "256 LUN" host response.
Refer to
• If an error screen appears under the following conditions, check the parameter settings.
-
-
-
-
-
-
-
3
Click the [Modify] button
 A confirmation screen appears.
4
Click the [OK] button.
 Changing of the FC host information starts.
"Host responses and recognizable LUNs" (page 818)
The "Name" is not entered
The "Name" does not satisfy the input conditions
The "Name" already exists
The "WWN" is not entered
The "WWN" does not satisfy the input conditions
The same "WWN" is already registered in the ETERNUS DX
There are some LUNs that cannot be recognized from the FC host because the "Host Response"
setting has been changed (only for FC hosts that are not registered in a host group)
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
424
for details.
P2X0-1270-13ENZ0