Eco-Mode Management; Modify Eco-Mode General Setting - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management

1.6 Eco-mode Management

1.6 Eco-mode Management
This section describes Eco-mode management.
The ETERNUS DX200F does not support Eco-mode management functions.
Eco-mode management provides the following functions.

• Modify Eco-mode General Setting

• Create Eco-mode Schedule
• Delete Eco-mode Schedule
• Modify Eco-mode Schedule
1.6.1 Modify Eco-mode General Setting
This function enables or disables the Eco-mode setting for the ETERNUS DX S3 series.
Eco-mode is not available for the following drives:
• Hot Spares (except Dedicated Hot Spares)
• SSDs and SSD SEDs
• A drive that is in a RAID group that satisfies the following conditions:
- A RAID group where no volumes are registered
- A RAID group where SDPVs are registered
- A RAID group that is registered as an REC Disk Buffer
- A RAID group where ODX Buffer volumes are registered
To create a new Eco-mode schedule, refer to
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
976).
The procedure to set the Eco-mode schedule for a RAID group is as follows:
Procedure
1
Click [Modify Eco-mode Setting] in [Action].
"1.6.2 Create Eco-mode Schedule" (page
75
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.1.5.1 Modify Eco-mode General Setting" (page
"Appendix B Modify Eco-mode General Setting" (page
76).
692).
P2X0-1270-13ENZ0