Fujitsu ETERNUS DX60 S3 User Manual page 270

Chapter 3 Volume Management
3.1 Create Volume
5
Click the [OK] button.
 The display returns to the initial screen.
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Capacity" does not satisfy the input conditions
• The "Enable" checkbox for "Use all Largest Free Space" is cleared and "Capacity" is not entered
• The "Enable" checkbox for "Use all Largest Free Space" is selected and the capacity of the created
WSV is 23MB or less
• The "Enable" checkbox for "Use all Largest Free Space" is selected and the capacity of the created
WSV is larger than the maximum capacity
• The "Set Value" checkbox is selected and "Volume No." is not entered
• The input value of "Volume No." exceeds the settable range
• The "Volume No." is specified and "Number of Volumes" is not "1"
• The "Number of Concatenation RAID Groups" field is left blank, "1" is specified, or a value that is
"65" or more is specified
• The maximum free space in the selected RAID group is smaller than the volume size that is to be
concatenated
• LDE is being performed in the target RAID group
To change the concatenation order of the RAID groups, select "Manual" for "Concatenation Order" in
the Volume Information field. Click the [Concatenation Order] link to display the [Setting
Concatenation Order] screen. The concatenation order of the RAID groups can be changed in the
[Setting Concatenation Order] screen.
6
After selecting RAID groups is complete, click the [Create] button.
 A confirmation screen appears.
270
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0