Appendix A Parameter List
A.1 System Management
A.1.3.6
Setup SMI-S Environment (for Controller Firmware Version V10L2x or earlier)
For details about this function, refer to
For the factory default settings for this function, refer to
●
Set SMI-S
•
SMI-S
Description
Input condition/
Display contents
A.1.3.7
Setup Power Management
For details about this function, refer to
For the factory default settings for this function, refer to
●
Power Control by External Device
•
RCIL
Description
Input condition/
Display contents
•
Auto Power
Description
Input condition/
Display contents
•
Power Resume
Description
Input condition/
Display contents
"1.4.6 Setup SMI-S Environment" (page
Select whether to "Enable" or "Disable" the SMI-S function.
•
Enable
•
Disable
"1.4.8 Setup Power Management" (page
Select whether to "Enable" or "Disable" the RCIL connection.
•
Enable
•
Disable
Select whether to "Enable" or "Disable" the power interlock mode (the function to
automatically power on when the power is supplied).
When PMAN is connected, enable the "Auto Power".
When the power synchronized unit is connected, disable the "Auto Power".
•
Enable
•
Disable
Select whether to "Enable" or "Disable" the auto power recovery mode (the function to
automatically power on at power recovery after a power failure).
•
Enable
•
Disable
678
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
43).
"Appendix B Setup SMI-S Environment" (page
48).
"Appendix B Setup Power Management" (page
973).
974).
P2X0-1270-13ENZ0