Fujitsu ETERNUS DX60 S3 User Manual page 267

Chapter 3 Volume Management
3.1 Create Volume
• When specifying the "Volume No.", select the "Set Value" checkbox and input the number.
• For the "Drive Type" field, the type of drive that configures the TPP is displayed.
If multiple drive types are used in the TPP, the drive type is displayed as described below:
-
-
-
• When creating a "TPV", the "Encryption by CM" setting cannot be changed.
• If an error screen appears under the following conditions, check the parameter settings.
-
-
-
-
-
-
-
-
4
Click the [Create] button.
 A confirmation screen appears.
5
Click the [OK] button.
 Volume creation starts.
6
Click the [Done] button to return to the [Volume] screen.
If the NAS volume creation fails, refer to
completed successfully" (page
If only "Online" type drives are used or if both "Online" and "Nearline" type drives are used,
"Online" is displayed.
If only "Online SED" type drives are used or if both "Online SED" and "Nearline SED" type drives
are used, "Online SED" is displayed.
If a single SSD type (SSD-M/SSD) is used or if multiple SSD types (SSD-M/SSD) are used, "SSD" is
displayed.
The "Name" is not entered
The "Name" does not satisfy the input conditions
The "Capacity" does not satisfy the input conditions
The "Set Value" checkbox is selected and "Volume No." is not entered
The input value of "Volume No." exceeds the settable range
The specified "Volume No." is already used
"Volume No." is specified and total number of values that are specified to "Number of Volumes"
is not "1"
The number of volumes that is specified for "Number of Volumes" exceeds the maximum
number of volumes that can be created
257).
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Procedures for when the NAS volume creation is not
267
End of procedure
P2X0-1270-13ENZ0