Chapter 4 Setup
>
4.4 Maintenance Setup
8
4.4.2
SNMP Device Monitoring Setup
This section explains how to perform settings to monitor event notification (Trap) by SNMP using
"ServerView", when the ETERNUS DX60/DX80 is connected to the Industry standard server
PRIMERGY.
IMPORTANT
Refer
Also, for events that are detected by ServerView when monitoring the device, refer to
B Events detected by ServerView" (page
Procedure
1
1-1
1-2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
Click the [Send Test E-mail] button to check that an E-mail can be sent to the
specified E-mail destination address.
Figure 4.38 Send Test E-mail
•
Use ServerView whose version is V3.60L20 or later.
•
For the details on the Industry standard server side settings, refer to
"ServerView User's Guide" that is provided with the PC server.
"ServerView User's Guide"
Set the network environment of the ETERNUS DX60/DX80.
When the ETERNUS DX60/DX80 and ServerView management device are in different
subnet environments, set the Gateway IP address and destination network address in the
[Setup Network Environment] screen of GUI.
Start GUI.
Click [Setup Network Environment] under the [Network Settings] menu on the [Global
Settings] tab in the GUI screen.
The [Setup Network Environment] screen appears.
195).
147
End of procedure
"Appendix
Copyright 2009 FUJITSU LIMITED