Fujitsu Eternus DX60 User Manual page 51

Chapter 2 Hardware
> 2.1 Components
2.1.2.1 Front view (with front cover)
POWER LED
Glows green when the power is turned on.
READY LED
Glows green when device is available for
use.
FAULT LED
Glows orange when an internal device part
abnormality has been detected. Blinks orange
when a predictive error has been detected.
IDENTIFY LED
Blinks blue or turns off as ordered via GUI to
identify the enclosure installation locations.
Figure 2.10 Front view of drive enclosure (with front cover)
2.1.2.2 Front view (without front cover)
Figure 2.11 Front view of drive enclosure (without front cover)
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
DISK STATUS LED
Glows or blinks green when disks
are operating normally.
Glows orange when a disk has failed.
Disk
Up to 12 can be installed in
the ETERNUS DX60/DX80.
AUTO POWER Switch
The AUTO POWER Switch of the
drive enclosure is set to "OFF" by
default, and should not be set to "ON".
MODE_SEL Switch
Enables the device power to be turned
on via power linkage
This switch is set to "ON" by default,
and should not be set to "OFF".
This is not used.
51
DE_No. label
Indicates the drive enclosure No.
Copyright 2009 FUJITSU LIMITED