Fujitsu Eternus DX60 User Manual page 82

Chapter 4 Setup
> 4.1 Prior Preparation
IP address and subnet mask for the ETERNUS DX60/DX80's MNT port of Slave CM
No default value is set.
This setting is required when enabling the MNT port of a Slave CM for dual controller model.
IP address and subnet mask for the ETERNUS DX60/DX80's RMT port
No default value is set.
This setting is required if the remote support connection is to be independent of the customer
network.
When enabling the RMT port of a Slave CM for dual controller model, two IP addresses are
required.
Gateway IP address
No default value is set.
IP address for the PC
Prepare an IP address for the PC (FST: Field Support Terminal) used by your maintenance
engineer.
IMPORTANT
Devices
Prepare the following device:
PC
The initial settings are performed by using a Web browser running on a LAN connected PC.
Prepare a PC installed with one of following Web browsers:
-
-
Refer
Networking equipment such as a switching hub
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
For dual controller model, from the MNT port of Slave CM, the device
status can be displayed, and a Master CM is switched to a Slave CM.
The ETERNUS DX60/DX80 can be reset to the factory default network
settings by pressing the Controller Enclosure's IP RESET Switch twice
in succession within a two second interval.
Web browser
Usable Web browsers are as follows. Using Web browsers other than the following is
possible, but proper operation cannot be guaranteed.
• Microsoft® Internet Explorer 6.0 or 7.0
• Mozilla Firefox™ 3.0.x
Resolution
1024 × 768 or greater
"ETERNUS DX60/DX80 Web GUI User Guide"
82
Copyright 2009 FUJITSU LIMITED