Fujitsu Eternus DX60 User Manual page 114

Chapter 4 Setup
> 4.3 ETERNUS DX60/DX80 Setup
Table 4.3
IP address of Disk Array
Subnet Mask
IP address of FST port
IP address of REMCS
port
Network settings for the PC to be used
Perform the following procedure to setup the PC to be used for setting up the ETERNUS DX60/
DX80.
Procedure
1
2
3
4
5
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Network Settings label fields
Items
IP address of the device MNT port
Subnet mask of network connected
IP address of PC (FST) used by maintenance engineer
IP address of the device RMT port
Connect the PC to the MNT port of the ETERNUS DX60/DX80 Controller 0
(CM#0) directly with a LAN cable (for operation management).
When a LAN cable (for operation management) is connected to Controller 1 (CM#1),
disconnect it.
Set the IP address and subnet mask of the PC.
Set the following values.
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Set the Web browser to not use a proxy server and a cache (Temporary Internet
Files).
Check that Java Script, style sheets, and cookies are enabled for the Web
browser.
Turn on the ETERNUS DX60/DX80.
• When turning on the ETERNUS DX60/DX80 for the first time,
IMPORTANT
volume formatting operation, which is set as factory default, may
be performed. However, the ETERNUS DX60/DX80 setting
operation can be continued.
• When stopping a volume formatting operation, delete the volume.
For details on deleting a volume, refer to "ETERNUS DX60/DX80
Web GUI User Guide".
Value
114
Copyright 2009 FUJITSU LIMITED