Chapter 4 Setup
>
4.2 Cable Connection
When 2U AC outlet box is installed
The procedure to connect the power cord to 2U AC outlet box is as follows:
Procedure
1
2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
Remove the power cord clamp from the AC outlet box.
Loosen the two thumb screws on both sides of the power cord clamp to remove it.
Power cord clamp
Connect the AC outlet box outlets and power unit inlets with power cord (AC
output cables) (4m).
The procedures to connect the power unit is the same as the
AC Outlet Box" (page
101).
The power unit for each enclosure is duplicated. The power cords
IMPORTANT
must be connected to the inlets of both power units (PSU#0 and
PSU#1).
The following table and figure show the connection path of an AC outlet cable and
connection figure respectively
108
Step 1
in
"4.2.6.1 With No
Copyright 2009 FUJITSU LIMITED