Fujitsu Eternus DX60 User Manual page 102

Chapter 4 Setup
> 4.2 Cable Connection
2
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Connect the power cords to the power outlet.
Connect the plug at the other end of each power cord to the power outlet.
WARNING
•
CAUTION
•
•
•
•
•
After unplugging the power cord, wait until the POWER STATUS
IMPORTANT
LED of the power unit has turned off completely before reconnecting
it.
(It takes about ten seconds for the STATUS LED to be turned off
completely.)
Do Not
Do not connect power cords or other cables during
thunderstorms, as lightning can result in fire or electric shock.
Do
Be sure to fully insert each plug into its socket. Failure to do
so may lead to fire or electrical shock.
Do Not
When disconnecting the power plug, be sure to pull from the
plug and not the cord. Pulling the cord may expose or snap
the inner wires, which can lead to fire or electrical shock.
Do not use the server service outlet to connect the device
power cord.
Do not overload an electrical outlet. Doing so may lead to
electric shock or fire.
Unplug
If the ETERNUS DX60/DX80 is not going to be used for a
long period of time, it is advisable to unplug all power cords to
avoid any chance of fire to the ETERNUS DX60/DX80 and its
peripherals.
102
End of procedure
Copyright 2009 FUJITSU LIMITED