Fujitsu Eternus DX60 User Manual page 91

Chapter 4 Setup
> 4.2 Cable Connection
LAN cable connection procedure
The following explains how to connect the LAN cable.
IMPORTANT
Procedure
1
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Do Not
CAUTION
• Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
Do not bend square
When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the
connector.
This section describes dual controller model as an example. Note that there
is only controller 0 (CM#0) for single controller model.
Connect the LAN cable to the ETERNUS DX60/DX80.
Insert the LAN cable connectors in the controller 0 (CM#0) and controller 1 (CM#1) iSCSI
ports.
90
Do not bind up
91
Copyright 2009 FUJITSU LIMITED