Chapter 6 Operation and Troubleshooting
>
6.5 Troubleshooting
6.5
Troubleshooting
If you notice anything unusual during operation, then refer to
check the ETERNUS DX60/DX80 status, accurately record the status on the form given
Trouble Record" (page
• Unusual phenomena during operation of the ETERNUS DX60/DX80
• When the ETERNUS DX60/DX80 is turned off
• When the ETERNUS DX60/DX80 refuses to be turned on
• When the READY LED is not on
• When the FAULT LED is on
• When the FAULT LED blinks
• When an IP address is forgotten
• When the license key cannot be registered
• When an ETERNUS DX60/DX80 related error message is displayed by the server
• When volume capacity is short
• When I/O access is slow
• When the server does not recognize the disks
6.5.1
Check List
Unusual phenomena during operation of the ETERNUS DX60/DX80
If the ETERNUS DX60/DX80 exhibits any of the following symptoms, unplug the ETERNUS
DX60/DX80 and cut the AC power at the distribution board, then contact your maintenance engi-
neer.
•
Abnormally hot
•
Unusual odor
•
Emission of smoke
•
Unusual noise
•
Abnormal shaking
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
184), and contact your maintenance engineer.
Unplug
WARNING
•
If the ETERNUS DX60/DX80 overheats, gives off smoke or an
unusual odor, makes an unusual sound, or shakes abnormally, or is
likely to be damaged by a power abnormality, immediately turn the
ETERNUS DX60/DX80 off and then pull the power plug from the
outlet.
After a while, check that unusual phenomena has disappeared, then
contact your maintenance engineer.
178
"6.5.1 Check List" (page 178)
Copyright 2009 FUJITSU LIMITED
to
"6.5.2