Chapter 3 Installation; Preparation; Placement Area; Check The Number Of Wall Outlets - Fujitsu Eternus DX60 User Manual

Chapter 3
This chapter describes the ETERNUS DX60/DX80 installation procedure.
Before installing the device, make sure to check the "ETERNUS DX60/DX80 Disk storage
system Safety Precautions".
Refer
3.1

Preparation

3.1.1

Placement Area

Installation area
Refer to the placement area of the rack to install the device.
Installation condition
Refer to "Instructions for installation" in "ETERNUS DX60/DX80 Disk storage system Safety Pre-
cautions" and set the device in a location where all the requirements are satisfied.
IMPORTANT
3.1.2

Check the number of wall outlets

Check the required type and number of the wall outlets.
Type of wall outlet connectors
All ETERNUS DX60/DX80 device models include US spec. AC200-240V cables (with plug) as
standard.
In addition, power cords must comply with the particular safety standards of the country of use. In
some cases, a power cord will need to be purchased locally to satisfy the relevant power safety
requirements.
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Installation
"ETERNUS DX60/DX80 Disk storage system Safety Precautions"
The speed of the ETERNUS DX60/DX80 fans is stepped up and down in
response to the ambient temperature.
Up to 25°C the noise level should not exceed about 42dB, but higher
temperatures or abnormal fan situations can result in noise levels over
42dB, and seclusion in a dedicated server room is generally recommended.
64
Copyright 2009 FUJITSU LIMITED