Fujitsu Eternus DX60 User Manual page 103

Chapter 4 Setup
> 4.2 Cable Connection
4.2.6.2 With an AC Outlet Box
The following explains how to connect the power cord when an AC outlet box is installed.
The following explains how to connect the power cord to 1U or 2U AC outlet box.
When 1U AC outlet box is installed
The procedure to connect the power cord to 1U AC outlet box is as follows:
Procedure
1
2
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Remove the power cord clamps from the AC outlet box.
AC outlet box
Connect the AC outlet box outlets and power unit inlets with power cord (AC
output cables) (4m).
The procedures to connect the power unit is the same as the
AC Outlet Box" (page 101).
The power unit for each enclosure is duplicated. The power cords
IMPORTANT
must be connected to the inlets of both power units (PSU#0 and
PSU#1).
The following table and figure show the connection path of an AC outlet cable and
connection figure respectively
Power cord clamps
103
Step 1 in "4.2.6.1 With No
Copyright 2009 FUJITSU LIMITED