Initial Setup - Fujitsu Eternus DX60 User Manual

Chapter 4 Setup
> 4.3 ETERNUS DX60/DX80 Setup
4.3.2

Initial Setup

Start Graphical User Interface (GUI) from the Web browser of the connected PC that is to be
used to set up the ETERNUS DX60/DX80, and perform the initial setup of the ETERNUS DX60/
DX80 in the following order.
• Set Date and Time
• Set Storage System Name
• Change Password
• Setup Network Environment
The initial setup procedure is as follows: For the setup details, refer to "ETERNUS DX60/DX80
Web GUI User Guide".
Refer
Procedure
1
1-1
1-2
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
• When checking the connection between PC used for setup and the
ETERNUS DX60/DX80, execute the "ping" command at the PC
command prompt.
The following is an example of ping execution: ("192.168.1.1" is the
default IP address)
ping 192.168.1.1
If the execution results in error, check the PC's network settings.
• If communication fails even though the MNT port of controller 0
(CM#0) and the LAN port of the PC are connected, check that
Master LED of controller 0 (CM#0) is lit. If the Master LED of
controller 1 (CM#1) is lit for dual controller model, use the MNT port
of controller 1 (CM#1).
"ETERNUS DX60/DX80 Web GUI User Guide"
Start the Initial Setup.
Start the Web browser on the PC that is to be used to set up the ETERNUS DX60/
DX80.
Enter either of the following URLs in the address bar of the Web browser.
http://192.168.1.1/
or
https://192.168.1.1/
115
End of procedure
Copyright 2009 FUJITSU LIMITED