Chapter 5 Setup; Basic Setup; Eternus Dx Disk Storage System And Pc Terminal Connection; Figure 5.1 Pc Terminal Connection For Initial Setup - Fujitsu Eternus DX60 S2 User Manual

Chapter 5
This chapter explains how to set up the ETERNUS DX Disk storage system.
5.1

Basic Setup

Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
5.1.1

ETERNUS DX Disk Storage System and PC Terminal Connection

Connect a PC terminal to the ETERNUS DX Disk storage system.
Use the LAN cable (for operation management) to directly connect the PC terminal to the MNT
port of Controller 0 (CM#0) in the controller enclosure.
Refer to
the PC terminal.
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Setup
"1.2 Setup Preparation" (page 24)
The ETERNUS DX Disk storage system and the PC terminal must be
connected directly since the network environment of the ETERNUS DX
Disk storage system is set using the PC terminal for the initial setup of the
ETERNUS DX Disk storage system.
Controller
enclosure
Figure 5.1
• If the LAN cable from the MNT port of Controller 0 (CM#0) is connected
to network devices, disconnect the LAN cable and then connect it to the
PC terminal.
• If the LAN cable from the MNT port is connected to Controller 1 (CM#1),
disconnect the LAN cable.
Copyright 2014 FUJITSU LIMITED
for LAN connection properties setup information of
LAN port
PC terminal
LAN cable
MNT port of Controller 0 (CM#0)
PC terminal connection for initial setup
80
P3AM-5502-05ENZ0