Fujitsu Eternus DX60 S2 User Manual page 77

Chapter 4 Connecting Cables
4.5 Power Cord Connection
Procedure
1
2
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Remove the power cord clamp from the power distribution unit.
Loosen the two thumb screws on both sides of the power cord clamp to remove it.
Power cord clamp
Connect the power distribution unit outlets and power supply unit inlets with the
power cords (AC output cables, 3m) provided with the power distribution unit.
The procedures to connect the power supply unit is same as the
Power Distribution Units are Installed" (page
Each enclosure has two power supply units (PSU#0 and PSU#1).
IMPORTANT
The power cords must be connected to the inlets of both power
supply units.
The following figure shows a connection diagram of AC outlet cables.
●
For Power distribution unit for ETERNUS DX Disk storage system (2U, Max 6
enclosures connection)
PSU#0
Inlet
Power distribution
unit A
Power distribution
unit B
: Connect between the OUTn of the power distribution unit A
and the PSU#0 inlets of the ETERNUS DX Disk storage
: Connect between the OUTn of the power distribution unit B
and the PSU#1 inlets of the ETERNUS DX Disk storage
Copyright 2014 FUJITSU LIMITED
72).
PSU#1
Drive Enclosure
Inlet
Controller Enclosure
PSU#0 Inlet PSU#1 Inlet
77
Step 1 in "4.5.1 When no
P3AM-5502-05ENZ0