Chapter 5 Setup
5.1 Basic Setup
7
7-1
7-2
7-3
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Finish the initial setup.
Click the [Finish] button.
The [Initial Setup] completes.
Device setting operation cannot be continued if the IP address is
IMPORTANT
changed. Log on again with the new IP address is required.
Remove the LAN cable (for operation management) from the PC terminal, and connect
the LAN cable (for operation management) of the MNT port of Controller 1 (CM#1) and
Controller 0 (CM#0) to the customer's network.
Start the Web browser, and log on again with the new IP address to perform the
configuration settings of the ETERNUS DX Disk storage system.
Copyright 2014 FUJITSU LIMITED
91
End of procedure
P3AM-5502-05ENZ0