Figure 1.9 Attaching Network Settings Label - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Preparation
1.2 Setup Preparation
❏ Attaching the Network Settings label
Attach the completed Network Settings label on the label plate in the label holder on the rear
upper side of the controller enclosure.
Label holder
Figure 1.9
■
Preparation and settings for the PC terminal
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
❏ Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
-
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
Plate
Tag
Pull out the plate while holding the tag.
Attaching Network Settings label
Web browser
Usable Web browsers are as follows. Using Web browsers other than the following is
possible, but proper operation is not guaranteed.
• Microsoft Internet Explorer 6.0, 7.0, 8.0, 9.0, 10.0 (desktop version)
• Mozilla Firefox 3.0.x, 3.5.x, 3.6.x, ESR 10.0.x, ESR 17.0.x
The following items are supported in firmware version V20L15 or
later:
• Internet Explorer 9.0, 10.0 (desktop version)
• Firefox ESR 10.0.x, ESR 17.0.x
Copyright 2014 FUJITSU LIMITED
Network Settings label
Network Setting
: . .
: . .
: . .
: . .
25
.
.
.
.
P3AM-5502-05ENZ0