Lan Connection Preparation For Operation Management; Completing And Attaching The Network Settings Label; Figure 3.2 Network Setting Label - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 3 Checking the Configuration Environment
3.4

LAN Connection Preparation for Operation Management

3.4 LAN Connection Preparation for Operation Management
3.4.1

Completing and Attaching the Network Settings Label

Enter the network setting information on the Network Settings label. Attach the Network Setting label on the
rack wall near the controller enclosure to avoid losing it.

Figure 3.2 Network Setting Label

IP address of MNT port
IP address of FST port
Subnet Mask of FST port
IP address of RMT port
Complete the following items in the Network Settings label.
• IP address of MNT port
Enter the IP address for the MNT port of the ETERNUS DX Disk storage system. The MNT port is a LAN port
that is used to perform operation management connection.
IP address of FST port
•
This item is not used. No information needs to be entered for this item.
Subnet Mask of FST port
•
This item is not used. No information needs to be entered for this item.
• IP address of RMT port
Enter the IP address for the RMT port of the ETERNUS DX Disk storage system. The RMT port is a LAN port
that is used during initial setup and to connect to the remote support center.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Network Setting
:
: . .
: . .
:
51
Copyright 2014 FUJITSU LIMITED
.
.
P3AM-7652-02ENZ0