Lan Cable Connection (For Operation Management) - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 5 General Settings
5.5

LAN Cable Connection (for Operation Management)

8
Logout
(1)
Click the [Close] button.
Initial setup 1 is complete and the screen returns to the [Login] screen.
(2)
Close the Web browser.
9
Remove the LAN cable that connects the RMT port to the PC terminal.
5.5 LAN Cable Connection (for Operation Management)
This ETERNUS DX Disk storage system must be connected to a LAN to perform actions via ETERNUS Web GUI
or ETERNUS CLI such as settings, maintenance operations, monitoring the device status, and using remote
support.
Prepare the required number of LAN cables for the network environment of the customer.
The following procedure explains how to connect the LAN cable.
When the LAN switch that is to be used has the Spanning Tree Protocol (STP) function enabled, connection
to the ETERNUS DX Disk storage system may fail. Use the following settings to disable the STP function:
• When the STP function is not necessary for the network configuration:
Disable the STP function of the LAN switch.
When the STP function is necessary for the network configuration:
•
Disable the STP function of the LAN switch port only for the ETERNUS DX Disk storage system connection
or perform the Port-Fast setting.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
84
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0