Chapter 5
General Settings
5.1
PC Terminal Connection
●
ETERNUS DX Disk Storage System Environment
Create the operation volume and backup volume in the ETERNUS DX Disk storage system.
Figure 5.2 Example of Creating Operation Volume and Backup Volume
ETERNUS DX Disk storage system
*1: SDV is used as the copy destination for SnapOPC+ and stores generation data.
*2: SDPVs are volumes that configure the SDP. The SDP is used to assign an area to an SDV when the SDV
capacity is insufficient. When SDPVs are not required, they are automatically released and restored to
their original status.
5.1
PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
For the setup information of the PC terminal, refer to
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
RAID group 0 (RAID5)
600GB 5
RAID group 1 (RAID5)
2TB 3
Copyright 2014 FUJITSU LIMITED
Operation volume
Standard
main
Backup volume
Snap Data Volume (SDV)(*1)
sdv0
sdv1
sdv2
Backup temporary work volume
Snap Data Pool Volume (*2)
sdpv
500GB
"3.3 Preparing the PC Terminal for Setup" (page
72
1TB
sdv3
sdv4
sdv5
sdv6
50).
P3AM-7652-02ENZ0