Fujitsu ETERNUS DX200 S3 Configuration Manual page 39

Chapter 2 Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
2
Attach the rack rails to the rack.
(1)
Insert the rack rails into the holes of the front and the rear rack pillars to lock the rail lock lever.
[Left]
(Rack pillar: front)
(2)
Use the M4 screws to fasten the front and the rear rack rails.
Use the washers to fasten the rack rails to the front and rear rack pillars.
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any
space between them.
M4 screw
The M4 screw positions for the rack rails are determined by the high-density drive enclosure base
line.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
[Right]
Rack rail
(left)
Washer
Washer
M4 screw
(Rack pillar: front)
Copyright 2014 FUJITSU LIMITED
Rail lock lever
Washer
M4 screw
(Rack pillar: rear)
Rack rail
(right)
39
(Rack pillar: rear)
Washer
M4 screw
P3AM-7652-02ENZ0