Fujitsu ETERNUS DX200 S3 Configuration Manual page 65

Chapter 4 Connecting Cables
4.4 Power Cord Connection
1
Remove the power cord clamp from the power distribution unit.
Power distribution unit
2
Connect the power distribution unit outlets and power supply unit inlets with the power cords (AC out-
put cables).
The procedures to connect the power supply unit is same as
tion Units are Installed" (page
The following figure shows an example of AC output cable connection:
PSU#0
Inlet
Power distribution unit
Outlet
OUTPUT #0-1
3
Connect the power cord (AC input cable) plugs to the inlets of the power distribution unit.
Power distribution unit
4
Use the power cord clamps to prevent the power plugs from coming unplugged.
Attach the power cord clamps removed in
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
63).
Drive enclosure 1
Controller enclosure
PSU#0 Inlet
Outlet
OUTPUT #0-2
: Connect OUTPUT#0-n of the Power distribution unit to the PSU#0 inlet of the ETERNUS DX Disk storage system
: Connect OUTPUT#1-n of the Power distribution unit to the PSU#1 inlet of the ETERNUS DX Disk storage system.
Inlet
INPUT #1
INPUT #0
Copyright 2014 FUJITSU LIMITED
Step 1
PSU#1
Inlet
PSU#1 Inlet
Outlet
OUTPUT #1-1
Outlet
OUTPUT #1-2
Inlet
Step 1.
65
Power cord clamp
in "4.4.1 When No Power Distribu-
P3AM-7652-02ENZ0