Server Connection Setup; Iscsi Initiator Parameter Settings (Connection Information Settings); Figure 8.1 Connection Configuration With Servers - Fujitsu ETERNUS DX200 S3 Configuration Manual

Chapter 8 SAN Connection Settings
8.2

Server Connection Setup

8.2 Server Connection Setup
Set up the server as required to connect to the ETERNUS DX Disk storage system.
The IP address to connect to the iSCSI network must be set on the server before the ETERNUS DX Disk storage
system is connected.
After the server connection setup is completed, confirm that the volumes in the ETERNUS DX Disk storage
system can be recognized by the server.

Figure 8.1 Connection Configuration with Servers

Server (host)
8.2.1

iSCSI Initiator Parameter Settings (Connection Information Settings)

Use the iSCSI Software Initiator to set the iSCSI initiator parameters.
After performing the settings, check the connection to the ETERNUS DX Disk storage system.
Turn on the ETERNUS DX Disk storage system while its iSCSI port is connected to the LAN port for iSCSI con-
nection on the server with the host interface cable. After confirming that the ETERNUS DX Disk storage sys-
tem is in READY status, turn on the server.
1
On the [iSCSI Initiator Properties] screen, click the [Discovery] tab.
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
A LAN card#0
iSCSI multipath
connection
LAN card#1
B
Copyright 2014 FUJITSU LIMITED
CA#0 Port#0 C
CM#0
CA#0 Port#0
D
CM#1
135
ETERNUS DX
Disk storage system
P3AM-7652-02ENZ0