Chapter 4 Connecting Cables; Lan Cable Connection (For Operation Management) - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 4
Connecting Cables
This chapter explains how to connect various cables to the ETERNUS DX Disk storage system.
CAUTION
4.1

LAN Cable Connection (For Operation Management)

This ETERNUS DX Disk storage system must be connected to a LAN to perform actions via ETERNUS Web GUI or
ETERNUS CLI such as settings, maintenance operations, monitoring the device status, and using remote
support.
LAN cables (enhanced Cat-5 type) must be obtained separately.
The following procedure explains how to connect the LAN cable.
• To help with LAN cable management and prevent incorrect connections, attach labels to the LAN cables
and make a note of connection origins and destinations.
• When connecting LAN cables, check the connector orientation and then firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the connector.
This section describes dual-controller type as an example. Note that there is only Controller 0 (CM#0) for a
single-controller type.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
• Make sure to wear a wrist strap or discharge static electricity by touching the
metal frame of the ETERNUS DX Disk storage system before starting each
operation, as failure to discharge static electricity may cause device failure.
65
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0