Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 110

Chapter 5 Setup
5.1 Basic Setup
■ For FC ports
Set the connection information for the FC ports on the ETERNUS DX Disk storage system and the server.
This section describes the port parameter settings when the port mode is "FC-CA" or "FC-CA/RA" (for server
connection).
For details on the port parameter settings for the "FC-RA" port mode (ports used for Remote Equivalent Copy
(REC)) or the "Initiator" port mode (ports used for Storage Migration), refer to "ETERNUS Web GUI User's
Guide".
Procedure
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the
[Connectivity] screen, click "FC" under "Port Group" in [Category].
The [FC Port Group] screen appears.
2
Select the checkbox for the FC port to set the port parameters for in the [FC Port Group]
screen and then click "Modify FC Port Parameters" in [Action].
The [Modify FC Port Parameters] screen appears.
3
Set the required items and click the [Set] button.
A confirmation screen appears.
4
Click the [OK] button.
The port parameter is set and the setting completion screen appears.
5
Click the [Done] button.
The screen display returns to the [FC Port Group] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
110
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0