Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 55

Chapter 3 Rack Installation
3.2 Installing Controller Enclosure
The M5 screw positions for the rack rails are determined by the controller enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the
2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
6th position
(M5 screw)
1st position
(M5 screw)
5th position
(M5 screw)
2nd position
(M5 screw)
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
2
Install the controller enclosure in the rack.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Front of controller enclosure
[Left]
2U
Base line of
controller enclosure
Rack rails
Rear of controller enclosure
[Left]
2U
Base line of
controller enclosure
Rack rails
Do
CAUTION
• When installing or removing the controller enclosure to or from the
rack, make sure that the sides and the bottom of the controller
enclosure are held by two or more people. Failure to do so may cause
injury.
Copyright 2013 FUJITSU LIMITED
[Right]
6th position
(M5 screw)
1st position
(M5 screw)
[Right]
5th position
(M5 screw)
2nd position
(M5 screw)
55
Step (1).
P3AM-4832-07ENZ0