Chapter 5 Setup
5.1 Basic Setup
■
For iSCSI ports
Set the connection information for the iSCSI ports on the ETERNUS DX Disk storage system and the server.
This section describes the port parameter settings when the port mode is "iSCSI-CA" or "iSCSI-CA/RA" (for
server connection).
For details on the port parameter settings for the "iSCSI-RA" port mode (ports used for Remote Equivalent
Copy (REC)), refer to "ETERNUS Web GUI User's Guide".
Procedure
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the
[Connectivity] screen, click "iSCSI" under "Port Group" in [Category].
The [iSCSI Port Group] screen appears.
2
Select the checkbox for the iSCSI port to set the port parameters for in the [iSCSI Port Group]
screen and then click "Modify iSCSI Port Parameters" in [Action].
The [Modify iSCSI Port Parameters] screen appears.
3
Set the required items and click the [Set] button.
A confirmation screen appears.
4
Click the [OK] button.
The port parameter is set and the setting completion screen appears.
5
Click the [Done] button.
The screen display returns to the [iSCSI Port Group] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
111
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0