Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 54

Chapter 3 Rack Installation
3.2 Installing Controller Enclosure
■ For regions other than EMEA&I
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front
and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be attached to
the rack before they can be completely tightened.
[Left]
(2)
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the four washers to fasten the
rack rails to the rear rack pillars.
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
M5 screws
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
(for left side).
(Front rack pillars)
[Right]
Rack rail (for left side)
Plate
Plate
(Front rack pillars)
M5 screws
Copyright 2013 FUJITSU LIMITED
(Rear rack pillars)
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
M5 screws
Washers
(Rear rack pillars)
Rack rail (for right side)
54
M5 screws
Washers
P3AM-4832-07ENZ0