Installing Power Distribution Unit (For Regions Other Than Emea&I); Installing Power Distribution Unit (1U) - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 3 Rack Installation
3.1 Installing Power Distribution Unit (For Regions other than EMEA&I)
3.1 Installing Power Distribution Unit (For Regions other than
EMEA&I)
This section describes how to install the power distribution unit in a rack.
CAUTION
3.1.1

Installing Power Distribution Unit (1U)

This section describes how to install the 1U power distribution unit in a rack.
Procedure
1
Remove the two brackets temporarily attached to the power distribution unit.
Remove the two M3 screws from the front of the power distribution unit to free the brackets.
M3 screw
2
Attach the brackets and holders to the rack.
M6 screws
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do Not
• Do not connect any devices other than the ETERNUS DX Disk storage system to
the power distribution unit.
Bracket A
Power distribution unit
M3 screw
Bracket A
Screw
holders
Holder
Holder
(Rear rack pillars)
M6 screws
Copyright 2013 FUJITSU LIMITED
Bracket B
Bracket B
Screw
holders
48
P3AM-4832-07ENZ0