Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 136

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
4-3
Click the [Set] button.
A confirmation screen appears.
4-4
Click the [OK] button.
The AIS Connect settings are applied.
4-5
Check the setting completion message and click the [Done] button.
The screen display returns to the remote support screen.
5
Confirm the connection of the ETERNUS DX Disk storage system and the AIS Connect server
in the remote support center.
5-1
In [Action], click [Test Server Connectivity].
A confirmation screen appears.
5-2
Click the [OK] button.
The connection with the server is checked. The result is displayed in the [Test Server Connectivity
Result] screen.
5-3
Click the [Done] button.
The screen display returns to the remote support screen.
6
Send the test event to confirm that the event is reported to the AIS Connect server.
6-1
In [Action], click [Send AIS Connect Test Event].
A confirmation screen appears.
6-2
Click the [OK] button.
The test event is sent to the AIS Connect server. The result is displayed in the [Send AIS Connect
Test Event Result] screen.
6-3
Click the [Done] button.
The screen display returns to the remote support screen.
5.2.5.2 Remote Support (by REMCS) Setup
When using the remote support function by REMCS, perform the environment settings for connecting to the
remote support center, and register the customer information to send to the remote support center.
If the AIS Connect function is being used, disable the AIS connect function and then start the remote support
(by REMCS) setup.
Procedure
1
Start ETERNUS Web GUI.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
136
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0