Chapter 4 Connecting Cables
4.1 LAN Cable Connection (For Operation Management)
Procedure
1
Connect the LAN cable to the ETERNUS DX Disk storage system.
Connect the LAN cable connectors to the MNT ports of the Controller 0 (CM#0) and Controller 1 (CM#1)
for the ETERNUS DX Disk storage system.
2
Connect the LAN cables to the networking equipment.
Connect the other end of the LAN cable to the networking equipment, such as LAN switch or router. For
networking equipment connection details, refer to the documentation for the networking equipment
being connected to.
3
If the RMT ports are to be used, connect the LAN cables to RMT ports.
3-1
Connect the connector of the LAN cable to the RMT port of the Controller 0 (CM#0) and Controller 1
(CM#1).
3-2
Connect the other end of the LAN cable to the networking equipment, such as LAN switch or router.
For networking equipment connection details, refer to the documentation for the networking
equipment being connected to.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
CAUTION
•
When connecting the LAN cables, position them so that they will not
obstruct replacement of the power supply unit or controllers by the
maintenance engineer.
Copyright 2013 FUJITSU LIMITED
66
End of procedure
P3AM-4832-07ENZ0