Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions page 123

Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
The syslog setting is explained below.
Procedure
1
Start ETERNUS Web GUI.
2
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3
In [Category], click [Network].
The [Basic] tab screen of the [Network] screen appears.
4
In [Action], click [Setup Syslog].
The [Setup Syslog] screen appears.
5
In the [Setup Syslog] screen, set the following items:
• Select "on(RFC3164)" or "on(RFC5424)" for "Send Log".
To send syslog messages in a message format that is defined with RFC5424 to a syslog server that
supports the RFC5424 format, select "on(RFC5424)". If not, select "on(RFC3164)".
• Enter the domain name or IP address of the syslog server in "Domain Name /IP Address".
6
Click the [Set] button.
A confirmation screen appears.
7
Click the [OK] button.
The syslog notification settings are applied.
8
Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
123
Copyright 2013 FUJITSU LIMITED
End of procedure
P3AM-4832-07ENZ0